I/o board, Removing the i/o board – Dell Inspiron 17 (N7010, Mid 2010) User Manual
Page 35
Back to Contents Page
I/O Board
Dell™ Inspiron™ N7010 Service Manual
Removing the I/O Board
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the module cover (see
Removing the Module Cover
).
4.
Follow the instructions from
step 4
to
step 6
in
Removing the Hard Drive
.
5.
Remove the optical drive (see
Removing the Optical Drive
).
6.
Remove the keyboard (see
Removing the Keyboard
).
7.
Remove the palm rest (see
Removing the Palm Rest
).
8.
Disconnect the I/O board cable from the connector on the system board.
9.
Remove the processor fan (see
Removing the Processor Fan
).
10.
Remove the display assembly (see
Removing the Display Assembly
).
11.
Remove the middle cover (see
Removing the Middle Cover
).
12.
Lift the I/O board off the computer base.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1 I/O board
cable
2 I/O board cable
connector