Dell 4350 Network Access Point - Manual (Page 141)

Back to Top
Start the Control Utility
The control utility program will run automatically upon each computer startup by default. If the utility does not start automatically,
run the Dell Wireless 4350 Small Network Access Point Dell Control Utility from the Start menu.
Once running, a access point icon is created in the system tray in the lower right corner of your screen. If you have a connection
to the access point, the system tray icon looks gray and white . You can double-click the icon to open the utility panel.
NOTE:
If the icon is red , it indicates that the connection to the access point failed.
Back to Top
Using the Control Utility to manage multiple Access Points
The control utility program can be used to manage multiple Dell Wireless 4350 Small Network Access Points. When the Control
Utility launches it will connect to the last access point configured. If you wish to configure an alternative Dell Wireless 4350 Small
Network Access Point on the network, then follow the instructions below.
1. Start the Dell Wireless 4350 Small Network Access Point Control Utility.
2. In the My Network Overview tab, enable the Configure Alternative AP checkbox.
3. Enter the IP address of the alternative Dell Wireless 4350 Small Network Access Point that you wish to configure in the IP
Address field.
4. Click Apply
5. The Control Utility will then shutdown. After restarting the Control Utility, it will have connected to the alternative Dell Wireless
4350 Small Network Access Point.
Back to Top
Exit the Control Utility
When you start the control utility program, it will place a small gray and white icon in the system tray in the lower right corner of
your screen. If you want to exit the program, right-click the icon, and then left-click Exit to quit the program.
Back to Top
Back to Contents Page