Dell 4350 Network Access Point - Manual (Page 240)

LED Represents Activity
Power Power The Power LED will light up green when the device is powered on and ready for use. It will
blink when the device is powering up or when it is reset
Wireless Wireless
LAN
The LED alternates between on and off when wireless clients are attached. It will blink when
there is data activity on the wireless network. The rate of blinking will vary with the rate of data
transfer. It turns off when no wireless clients are associated with the Dell Wireless 4350 Small
Network Access Point.
Ethernet Intranet A steady green light indicates the connection is active, and blinks with data activity.
Back to Top
Back Panel
Back Panel
Connector Description
Lock This accepts locking devices for protecting the Dell Wireless 4350 from theft.
Reset Use an object, such as a paper clip, to press the button for at least 5 seconds. The Power LED will be off
for a short time and then light up again. You can then release the button to reset the device to its factory-
default settings.
Ethernet This accepts an RJ-45 connector for network cabling.
*Also accepts power input from Ethernet port (Power Over Ethernet)
Power Connect the power adapter to this Power port, and then plug the other end of the power cable into a
power outlet.
Back to Top
Back to Contents Page