Dell XPS 600 - Manual (Page 30)

Removing and Installing Parts: Dell XPS 600 Service Manual
parts0.htm[4/10/2014 9:50:52 PM]
1 PCI Express x16 card
2 PCI Express x16 card slot
3 securing tab
6. If you are replacing the card, see " Installing PCI Express Graphics Cards in a Dual Configuration ."
If you are not replacing the card, install a filler bracket in the empty card-slot opening.
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the
computer. The brackets also keep dust and dirt out of your computer.
NOTE: The graphics card bridge is unnecessary in a single card configuration.
7. Before you lower the retention arm, ensure that:
The tops of all cards and filler brackets are flush with the alignment bar.
The notch in the top of the card or filler bracket fits around the alignment guide.
NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer
cover from closing properly or cause damage to the equipment.
8. Press the retention arm into place, securing the card(s) in the computer.
1 filler bracket
2 alignment guide
3 alignment bar
4 retention arm