Dell XPS 600 - Manual (Page 39)

Removing and Installing Parts: Dell XPS 600 Service Manual
parts0.htm[4/10/2014 9:50:52 PM]
1 filler bracket
2 alignment guide
3 alignment bar
4 retention arm
9. Connect any cables that should be attached to the card.
See the documentation for the card for information about the card cable connections.
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug the cable into
the computer.
10. Replace the computer cover, reconnect the computer and devices to electrical outlets, and then turn them on.
11. If you installed a sound card or a network adapter, see " Network Adapter and Sound Card Settings ."
12. Install any drivers required for the card as described in the card documentation.
Network Adapter and Sound Card Settings
If you installed a sound card:
1. Enter system setup, select Integrated Audio Controller, and then change the setting to Off.
2. Connect external audio devices to the sound card connectors. Do not connect external audio devices to the microphone,
speaker/headphone, or line-in connectors on the back panel.
If you removed a sound card:
1. Enter system setup, select Integrated Audio Controller, and then change the setting to On.
2. Connect external audio devices to the audio connectors on the back panel of the computer.
If you installed an add-in network adapter and want to disable the integrated network adapter:
1. Enter system setup, select Integrated NIC Controller, and then change the setting to Off.