Dell XPS 600 - Manual (Page 45)

Removing and Installing Parts: Dell XPS 600 Service Manual
parts0.htm[4/10/2014 9:50:52 PM]
11. Close the computer cover .
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into your
computer.
12. Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
13. If the drive you just installed is the primary drive, insert a bootable floppy disk into drive A.
14. Turn on the computer.
15. Enter the system setup program , and update the appropriate Drive option.
16. Exit the system setup program, and restart the computer.
17. Partition and logically format your drive before you proceed to the next step.
See the documentation for your operating system for instructions.
18. Test the hard drive by running the Dell Diagnostics.
19. If the drive you just installed is the primary drive, install your operating system on the hard drive.
Adding a Second Hard Drive