Qmark CPH - Decorative and Commercial Pedestal Heaters - Manual

Read Carefully – These instructions are written to help you
prevent difficulties that might arise during installation of these
Pedestal Heaters. Studying these instructions first may save
you considerable time and money later. These Pedestal
Heaters are designed for easy and economical installation.
Follow these instructions to keep your installation time to a
minimum.
1. Read all instructions before using the heater.
2. Hazard of fire or electric shock – To avoid possible electri-
cal shock, be sure electricity is turned off at main switch first
before wiring. All wiring must be in accordance with the
National Electrial Code (NEC) applicable local codes and
the entire heater installation must be grounded as a pre-
caution against possible electrical shock.
3. Check the supply voltage to make sure it is the same as
indicated on the heater nameplate before energizing.
4. Do not install heaters against combustible low-density
cellulose fiberboard surfaces.
5. Due to variations in vinyl compositions and their potential to
discolor, the use of stand off brackets (SO1A and SO2A)
and / or specifying a lower watt density unit may be required
when installing on vinyl wall coverings or under vinyl window
dressings.
6. The ends of the heater must be fully closed by the use of
adjoining heaters, end caps, or other accessories.
7. Do not locate the heater below an electrical convenience
receptacle.
8. A heater has hot and arcing or sparking parts inside. Do not
use it in areas where gasoline, paint, or flammable liquids
are used or stored. Do not install this heater upside down
or where water is present.
9. This heater is hot when in use. To avoid burns, do not let
bare skin touch hot surfaces. Keep combustible materials,
such as furniture, pillows, bedding, papers, clothes, and cur-
tains away from heater.
10. To prevent possible fire, do not block air intakes or exhaust
in any manner.
11. Do not insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electric shock or
fire, or damage the heater.
12. Discard packing pads before heater is used.
See also additional warnings located in this manual
Dear Owner,
Congratulations! Thank you for purchasing this new heater manufactured by Marley Engineered Products.
You have made a wise investment selecting the highest quality product in the heating industry.
Please carefully read the installation and maintenance instructions shown in this manual. You should enjoy
years of efficient heating comfort with this product from Marley Engineered Products... the industry’s leader in
design, manufacturing, quality and service.
... The Employees of
Marley Engineered Products
SAVE THESE INSTRUCTIONS
CPH and DPH
Convectors
IMPORTANT INSTRUCTIONS
Commercial Pedestal
Convection Heater
(Type CPH)
Decorative Pedestal
Convection Heaters
(Type DPH)
WARNING
!