Qmark CHPR25 - Compact Freeze Protection Heater - Manual

CFP25
Horizontal Plenum Heater
9900268
Dear Owner,
Congratulations! Thank you for purchasing this new heater manufactured by Marley Engineered Products. You have made a
wise investment selecting the highest quality product in the heating industry. Please carefully read the installation and main-
tenance instructions shown in this manual. You should enjoy years of efficient heating comfort with this product from Marley
Engineered Products... the industry’s leader in design, manufacturing, quality and service.
... The Employees of Marley Engineered Products
Read Carefully - These instructions are written to help you
prevent difficulties that might arise during installation of
heaters. Studying the instructions first may save you consid-
erable time and money later. Observe the following proce-
dures, and cut your installation time to a minimum.
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR
HEATER FALLING:
1. Use minimum 75ºC copper wire only.
2. Verify the power supply voltage coming to heater match-
es the ratings printed on heater nameplate before ener-
gizing.
3. Heater air flow must be directed parallel to, or away from
adjacent walls.
4. Observe wall, floor, and ceiling clearance requirements.
See Figure 1
5. All wiring must conform to national and local electrical
codes and the heater must be grounded as a precaution
against possible electrical shock. Heater circuit must be
protected with proper over current protection. See unit
nameplate.
6. The mounting structure and the anchoring hardware
must be capable of reliably supporting the weight of the
heater and if used, the mounting bracket.
7. All electrical power must be disconnected at the main
service box before installing, inspecting, cleaning or ser-
vicing the heater. This is a precaution to prevent possible
electrical shock.
8. This heater is not suitable for use in hazardous location
as defined by the National Fire Protection Association
(NFPA). this heater has hot and arcing (sparking) parts
inside. Do not use in areas where gasoline, paint, or
flammable liquids are used or stored.
10. Improper installation or failure to follow the procedures
outlined in this instruction manual can result in serious
electrical shock.
Installation & Maintenance Instructions
READ AND SAVE THESE INSTRUCTIONS
WARNING
!
CFP25 SPECIFICATIONS- Ratings @ 0.20” SP
VOLTS HZ KW PHASE BTUH CFM FPM RISE AMPS*
240 50 / 60 2.5 1 8530 150 1880 60°F 10.7
208 50 / 60 1.9 1 6398 130 1880 46°F 9.42
(Thermostat temperature range : 40°F to 90°F)
* Includes motor amps.