Qmark RV16 - Attic Ventilators - Manual

READ AND SAVE THESE INSTRUCTIONS
RV 16
POWERED ATTIC VENTILATOR
WARNING
To Reduce The Risk Of Fire Or Electrical Shock, Do Not Use This
With Any Solid-State Speed Control Device.
GENERAL SAFETY GUIDELINES
1. Please read all the instructions carefully before installing this ventilator. Failure to follow instructions
could cause serious bodily injury and/or property damage.
2. WARNING: TO AVOID POSSIBILITY OF ELECTRIC SHOCK OR OTHER SERIOUS INJURY, THE
INSTALLER MUST KEEP ALL ELECTRIC POWER TO FAN DISCONNECTED
DURING INSTALLATION AND WIRING.
3. Electrical connections and all wiring should be in accordance with the National Electrical Code and all
local codes that may apply.
4. THIS VENTILATOR IS INTENDED TO BE INSTALLED SUCH THAT THE UNGUARDED FAN BLADE
FACES AN UNOCCUPIED SPACE ONLY. THE UNGUARDED FAN BLADE ON THIS VENTILATOR
SHOULD NEVER BE EXPOSED TO AN AREA OCCUPIED BY PEOPLE OR ANIMALS.
5. WARNING: TO AVOID POSSIBILITY OF ELECTRIC SHOCK OR OTHER SERIOUS INJURY
TURN OFF ALL ELECTRICAL POWER - REMOVE FUSE OR DISCONNECT CIRCUIT
BREAKER - BEFORE SERVICING UNIT!
6. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back drafting. Follow the heating equipment manufacturer’s guideline and safety
standards such as those published by the National Fire Protection Association (NFPA), and the American
Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and local code authorities.
ATTENTION
THIS VENTILATOR’S FLASHING PLATE MAY POSSIBLY HAVE BEEN DISTORTED DURING SHIPPING AND
HANDLING. ANY SUCH DISTORTION DOES NOT REPRESENT DEFECTIVE PRODUCT AND IS NOT
RETURNABLE FOR THAT REASON. FLASHING MATERIAL IS PURPOSELY DESIGNED TO BE SOFT AND
FLEXIBLE IN ORDER TO ALLOW THE FLASHING PLATE TO CONFORM TO THE CONTOUR OF THE ROOF.