Qmark 1080 General Home/Kitchen Fans - Manual

READ AND SAVE THESE INSTRUCTIONS
MODEL 1080
VENTILATOR
GENERAL
Model 1080 is designed for ceiling installation with vertical discharge through the ceiling by means of round duct.
Model 1080 is operated by means of a wall switch. Be careful when handling the motor blade assembly, to avoid
bending the blades.
UNPACKING
Unpack carefully. If there are missing components or hidden dam-
age, immediately contact your distributor or the delivering carrier
concerning discrepancies.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
TO REDUCE RISK OF FIRE, ELECTRICAL SHOCK
OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Do not use this fan with any Solid-State speed control device.
2. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer.
3. Before servicing or cleaning unit, switch power off at service
panel and lock service panel to prevent power from being
switched on accidentally.
4. Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and stan-
dards, including fire-rated construction.
5. Sufficient air is needed for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment to
prevent back drafting. Follow the heating equipment manufac-
turer’s guideline and safety standards such as those published
by the national Fire Protection Association (NFPA), and the
American Society for Heating Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code authorities.
6. When cutting or drilling into wall or ceiling, do not damage elec-
trical wiring or other hidden utilities.
7. Ducted fans must always be vented to the outdoors.
8. If this unit is installed over a tub or shower, it must be marked as
appropriate for the application.
9. NEVER place a switch where it can be reached from a tub or
shower.
10. CAUTION: For General Ventilating Use Only! Do not use to
exhaust hazardous or explosive materials and vapors.
11. Not for use in kitchens.
Dimensions
FIG. 1