Qmark 1080 General Home/Kitchen Fans - Manual (Page 2)

TOOLS
Installation of your Marley product is easy. No special technical knowledge is needed. Only a few ordinary
tools are required:
Screwdriver
Hammer
Saber saw, Keyhole saw, or Jig saw
Electric drill with bit
Wire cutters
Wire stripper
Wire nuts and general electrical supplies
Safety glasses
Ruler and straight edge
All hand tools should be insulated. Power tools should display the UL Listing Mark.
NEW HOME INSTALLATION
1. Provide for a round hole 11 1 ⁄
8
” in diameter in the ceiling construction.
2. If a reducer is to be used to get to 8” diameter duct, remove the screws and mount it to the sleeve, so
that the screw holes align with the slots in the sleeve. Replace the screws.
3. Attach brackets to sleeve with screws provided in the envelope. Nail or screw brackets to joist.
4. Adjust sleeve so that flange will be flush with the finished ceiling.
5. Pull power cable through outlet box opening. Attach cable to outlet box, using an approved connector.
Splice cable to receptacle leads in outlet box cover. Ground wire may be attached to grounding bolt in
outlet box. Power line should be run to switch box holding toggle or Model 1011A Timer. See Fig. 3.
6. Push outlet box and outlet cover into place and fasten with screws.
7. Install motor blade assembly. Insert bottom of motor bracket into holes in outlet box cover. Engage key
hole slot over screw in top of ventilator and tighten, making sure that blade is centered in sleeve. Be
sure power is off, then insert plug into receptacle.
8. Attach grille with knob.
9. Finish installation by adding sufficient 11” pipe to go through the roof and installing a Roof Cap. See Fig. 4.
FIG. 2
FIG. 3
STANDARD WALL SWITCH GROUND
SCREW
OUTLET BOX SWITCH BOX
EARTH GROUND
120VAC
60Hz
SUPPLY
CEILING JOIST
MOUNTING
BRACKET