Sony CCD-TR930 - Manual (Page 22)

I Advanced operations
Using alternative power sources
You can choose any of the following power sources for your camcorder: battery pack,
the house current, alkaline battery and 12/24 V car battery. Choose the appropriate
power source depending on where you want to use your camcorder.
Place Power source Accessory to be used
Indoors House current Supplied AC power adaptor
Outdoors Battery pack InfoLITHIUM battery NP-F330 (supplied),
NP'F530, NP-F730, NP-F930
Size AA (LR6) Alkaline battery Battery case (supplied)
In the car 12 V or 24 V car battery Sony car battery charger EX2-V515A
Note on power sources
Discormecting the power source or removing the battery pack during recording or
playback may damage the inserted tape. If this happens, restore the power supply again
immediately.
Usinilhe house current . Г; <
To use the supplied AC power adaptor:
( 1 ) Connect the AC power cord to a wall outlet.
( 2 ) Slide the connecting plate down into the guides at the rear of the camcorder
until it clicks.
To remove the connecting plate
The connecting plate is removed in the same way as battery pack.
WARNING
The power cord must only be changed at a qualified service shop.
PRECAUTION
The set is not disconnected from the AC power source (mains) as long as it is connected
to the wall outlet, even if the set itself has been turned off.
Notes on the VTR/CAMERA lamp
• The VTR/CAMERA lamp will remain lit for a while even if the unit is unplugged
after use. This is normal.
• If the VTR/CAMERA lamp does not light, disconnect the power cord. After about one
minute, recormect the power cord.
22