Trouble check – Sony CCD-TR930 User Manual

Page 56

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

56

Trouble check

If you run into any problem using the camcorder, use the following table to
troubleshoot the problem. Should the difficulty persist, discormect the power source
and contact your Sony dealer or local authorized Sony service facility.

Power

Symptom

Cause and/or Corrective Action

The power is not on.

• The battery pack is not installed.

Install the battery pack. (p. 8)

• The battery is dead.

Use a charged battery pack. (p. 6)

• The AC power adaptor is not connected to a wall outlet.

Connect the AC power adaptor to a wall outlet, (p. 22)

• You use other types of battery except an "InfoLITHIUM"

battery pack.

Use an "InfoLITHIUM" battery pack (p. 6)

The power goes off.

• While being operated in CAMERA mode, the camcorder

has been in Standby mode for more than 5 minutes.

Turn STANDBY down once and then up again, (p. 12)

• The battery is dead.

-> Use a charged battery pack. (p. 6)

• If VF PW-SAVE is set to ON, the picture disappears

automatically when you turn your face away from the
viewfinder.

Bring your face close to the viewfinder within 1/2 inch
(1 cm). Or set VF PW-SAVE to OFF. (p. 25)

The battery pack is quickly
discharged.

• The ambient temperature is too low. (p. 49)
• The battery pack has not been charged fully.

Charge the battery pack again, (p. 6)

• The battery pack is completely dead, and cannot be

recharged.
■> Use another battery pack. (p. 8)

• You use other types of battery except an "InfoLITHIUM"

battery pack.

Use an "InfoLITHIUM" battery pack (p. 6)

The beep sounds when the
battery is attached.

• The battery pack is discharged during a long period of

storage.

Charge the battery pack again, (p.6)

When you turn off the power,
the lens makes a noise.

• The camcorder is not malfunctioning.

Operation

Symptom

Cause and/or Corrective Action

START/STOP does not
operate.

• The tape is stuck to the drum.

Eject the tape. (p. 10)

• The tape has run out.

-> Rewind the tape or use a new one. (p. 20)

• The POWER switch is set to VTR.

Set it to CAMERA, (p. 11)

• The tab on the cassette is out (red).

■> Use a new tape or slide the tab. (p.lO)

Advertising