Sony IT-M202 - Manual (Page 13)

Additional tasks
To Do this
Adjust the handset volume During phone conversation, set the HANDSET
VOLUME switch. You can select from three
level positions.
Adjust the speaker volume Slide the SPEAKER VOLUME control.
Adjust the ringer volume You can adjust the ringer level of line 1 and 2
respectively. Set the RINGER LEVEL LINE 1 or
LINE 2 switch to H (high) or L (low); to turn the
ringer off, set to OFF.
Put a call on hold Press ( HOLD ). The LINE 1 or LINE 2 button
will flash slowly.
Press (
LINE 1 ) or C LINE 2") to resume the
conversation.
Mute your voice Press C MUTING ) to disable the microphone. The
MUTING lamp liehts up. Press C MUTING) again
to cancel.
Switch to tone dialing
temporarily Press TONE (TT) after you're connected.
The line will remain in tone dialing until
disconnected.
OD
(U
VI
Q
Notes
• When another extension connected to LINE 1 or LINE 2 is in use, the LINE 1
or LINE 2 button flashes.
• When another call comes in on the other line, the corresponding line button
flashes, but the phone won't ring, (see page 17).
Tips
• You can switch to speakerphone during conversation by pressing
(SPEAKERPHONE ). Then you can replace the handset in the cradle.
To switch back to the handset, pick up the handset again.
• If you pick up another phone connected to the same phone line, the hold will
be automatically released and you will be able to resume conversation on
that phone.
• When you pick up the handset or press ( speakerphone ), the vacant line is
automatically connected. When neither line is in use, line 1 is connected.
continued
Basics
13