Sony CDP-997 - Manual (Page 27)

Playing the Program
To play the selections for side B
When the selections for side A are played, the player will
pause. Set the tape to the beginning of side B (“B" lights
up.), then press ^ or
II.
To stop playing
Press ■.
To cancel multi-disc program
Press CONTINUE and return to the continuous playing
mode. The program will be erased.
To check your program
Press CHECK. Each time you press CHECK, the selection
in the program will be displayed along with its selection,
order and disc number.
When CHECK is pressed after the last selection “-END-"
appears and then the display returns to the initial display.
To Change Your Program
You can make the following changes before starting play.
To erase the last selection
Insert the last disc programmed and press CLEAR. Each
time you press CLEAR, the last selection in the program
will be erased. To continue erasing selections, replace the
disc accordingly and repeat the procedure.
If a pause has been programmed, the selections
programmed before the pause cannot be cleared.
To add a selection to the end of the program
Insert a disc and press the numeric button for that
selection.
You can add a selection during stop.
To erase the entire program
Press ■ once during stop; twice during play. The program
will be erased.
If you make a mistake in the disc order
Even if a disc is inserted in an incorrect order, the selections chosen from
that disc will be played. However, when a disc which has already been
played is inserted, program play will not proceed. In addition, when a seventh
disc is incorrectly inserted, “DISC FULL" will be displayed.
To check the remaining time In multi-disc program play
Press TIME/MEMO (or TIME on the remote commander) once to see the
remaining time of the selection being played; twice to see the remaining time
of the disc being played. The remaining time of the program cannot be
displayed tor multi-disc programs.
27