Sony SPP-A967 - Manual (Page 6)

10"'
step 3: Preparing the battery pack (continued)
Battery duration
A full\- charged battery pack lasts for about:
• 6 hours when you use the handset continuously
10 da\'s (RINCi ON moctc) or 1 month (KING CtFF mode) v\ hen the
handset is in standby mode.
Notes
• The batter\' pack will gradualK discharge o\ er a long period ot time, e\ en it
not in use.
• If you leaye the battery pack in the handset without charging it, the battery
pack v\ ill becompleteh discharged.
It may require seceral times r)f charging to recover to its tull capacity.
• While charging, tlie battery pack warms up. 'Hiis is not a malfunction.
To obtain the best performance from the battery
Do not palace the handset on the base unit after each call. The battery
works best if the handset is returned to the base unit after two or three
calls. However, do not leave the handset off the base unit for a long
period of time as this will compaletelv discharge the battery pack.
When to purchase a new battery pack
If the battery lasts only a few minutes even after 12 hours of charging,
the usable life of the battery' has expaired and needs repalacement.
Contact your local Sony authorized dealer or service center, and ask
for Sony BP-T24 rechargeable battery paack.
Note
battery lite may yary depaending on usage condition and ambir'ut tempaerature.
Getting Started
Step 4
Entering your area code
When you use this phone tor the first time, or move to an area that has
a different area code, you must enter your area code.
This is necessary because the phone must distinguish local or bang
distance calls to paropaerlv dial calls from the Caller ID list.
1
Press I VOUPGrr).
2
Turn Jog Dial up to make "AREA"
flash.
directory -'^№
Press Jog Dial.
"ENTER AREA CODE" apapears on
the display.
4 Enter three ciigits of your area code
using ‘
5
Press C vODPGtT.
, the dialing kevs.
You hear a long confirmation beep.
Notes
• K an area code is already entered, it appears on the display in step 3. t o enter
a different area code, see "To change the area code" below.
• Do not allow HTctre than 20 secoiids to elapse between each step of the
prtx'edii re
Tips
• h oLi ma\- press log Dial instead of .,'VOL/PGM' iit step 3.
• it' check the current area code, perk^rm steps 1 to 3 abo\ e. The area code
appears on the displa\' k>r 20 seconds.
To change the area code
1
Perform stepis 1 to 3 abo\ e.
The current area code apapears on the dispalav.
2
Turn Jc)g Dial down to erase the current area code.
3
Enter a new area code using the dialing kevs.
4
Press C vol / pgm T.
T oil hear a long confirmation beep. Getting Started