If the battery becomes weak during a call, Redialing, Note – Sony SPP-A967 User Manual

Page 9: To check the phone number before redialing, To erase the last phone number dialed, If you have subscribed to the caller id service, Additional tasks, Receiving calls, Cqee)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

If the battery becomes weak during a call

The handset will beep e\ er\' three seconds anci and "B.ATTTR't'
L-OW" appears on the display. Finish vour call and charge the batter\
pack.

For optimum performance, charge the battery for a full 12 hours.

Note that during the first 10 - 15 minutes of charging, the phone will
be inacti\ e, i.e., unable to make or recoix e a call.

After this initial 10 - 15 minutes, you may be able to use the phone, but
the batterv duration will be very short; thus it is recommended that

vou fully charge the battery before next use.

Making calls (continued)

Redialing

1

Press (T

alk

I and wait until "TALK" appears on the display.

The IN USE lamp on the base unit lights up.

2

Press (

redial

)

to reciial the number last dialed.

Note

If the number exceeds 32 digits or if it is erased, five short error beeps will alert

vou that the number cannot be dialed.

To check the phone number before redialing

Without pressing (

talk

), press (

redial

).

The number last dialed is displayed for fix e seconds.

To dial the number, press (TALK) while the number is displayed.

Note

The number will not be dispalayed if the last dialed number exceeds 32 digits or
it it is erased.

To erase the last phone number dialed

While the handset is not in use, press (T

iedial

T tvx'ice.

The number will be erased from the memory, and v'ou xvill hear a long
confirmation beep.

Receiving calls

When you hear the phone ring,

pick up the handset from the
base unit, and press C

ta

DT) .

"TALK" appears on the display
and the IN USE lamp on the

base unit lights upa.

During a conversation, you can
adjust the handset volume.
Follow the procedure described
in the table below.

When you're done talking, press

CQEE)

or replace

the

handset on

the base unit.

The display and the IN USE

lamp on the base unit go off.

If you have subscribed to the Caller ID service

• the caller's number and/or name appears on the display when vou receive a call (see page 37

• the ringer st)und changes to a higher tone if the call matches the number stored on 0\E-

TOUCI i Dl,'\L buttons or in the Phone Directory (memory match function: see page 37).

Additional tasks

To

Do this

Adjust the handset volume

During phone conversations, pressCx/OL/PGM/; .
Fach press of fVOL/PGM) switches the speaker volume bv
four levels.

Switch to another call

("call waiting" serxice"”)

IVt'ss ("CALL WAITING/FLASH),
I’ress ' CALL

waiting

/

f

L

ash

, acain to return to the ¡irst caller

* You need to subscribe to the seiA’ice from vour telephone companv.

Tip
To inform \’c>u ot an incomingcall, the dispia\' shows ";k^RINCtlNCi^^" when

ringing.

continued

16"'

Basics

Basics

Advertising