Sony SPP-A973 - Manual (Page 25)

Press
(PGM).
"ENTER NUMBER" appears.
Enter the phone number.
You can enter up to 32 digits, including a tone
and a pause, each of which is counted as one
digit.
When the phone number of 17 digits or more
has been entered, the phone number appears in
two lines.
U Press (TO®.
You will hear a long confirmation beep, and the
name and the number are stored. The display
goes off.
Notes
• If you intend to save a 51st phone number, you will hear five short error
be^s and "MEMORY FULL" will be displayed. You cannot store the phone
number. To store another phone number, erase one of the stored phone
numbers (see page 27).
• Do not allow more than 20 seconds to elapse between each step of the
proadure.
• The total number of phone numbers which can be stored into the Phone
Directory varies according to the number of digits of each phone number, if
all the phone numbers consist of up to 16 digits, you can store up to 50 phone
numbers. However, as the Phone Directory uses two-phone number memory
to store one phone number of 17 digits or more, the total number of phone
numbers which can be stored in the Phone Directory decreases two by two
every time you store a phone number of 17 digits or more.
Tips
• If you have entered a wrong name or number in step 3 or 5, turn Jog Dial
down to erase it. Then enter the correct name or number.
• You may press jog Dial instead of (PGM) in steps 4 and 6.
•o
3"
0
3
fD
fiJ
c
tS
To store a number to be dialed via Private Branch Exchange
(PBX)
Before entering a phone number in step 5 above, do as follows:
1 Enter the outside line access digit (e.g., 9).
2
Press ( PAUSE ). continued
Telephone Features 2S^