Sony SPP-A973 - Manual (Page 3)

12. Unplug this product from the wall
outlet and refer servicing to qualified
service personnel under the following
conditions:
A. When the power cord or plug is
damaged or frayed.
B. If liquid has been spilled into the
prpduct.
C. If the product has been exposed to
rain or water.
D. If the product does not operate
normally by following the operating
instructions. Adjust only those
controls that are covered by the
operating instructions because
improper adjustment of other controls
may result in damage and will often
require extensive work by a qualified
techrucian to restore the product to
normal operation.
E. If the product has been dropped or
tihe cabinet has been damaged.
F. If the product exhibits a distinct
change in performance.
13. Avoid using a telephone (other than
a cordless type) during an electrical
storm. There may be a remote risk of
electric shock from lightning.
14. Do not use the telephone to report a
gas leak in the vicinity of the leak.
SAVE THESE
INSTRUCTIONS
CAUTION:
To reduce the risk of fire or injury to persons by
battery, read and follow these instructions.
1. Use only the following type and size battery
pack: Sony BP-T23.
2. Do not dispose of the battery pack in a fire.
The cell may explode. Check with local codes
for possible special disposal instructicms.
3. Do n(A open or mutilate the battery pack.
Released electrolyte is corrosive and may
cause damage to the eyes or skin. It may be
toxic if swallowed.
4. r.xcrcisu cari' In hiindlin^ batU-ry p«u k in
order not to short the battery with condu< tin>;
materials such as rings, bracelets, and keys
The battery or conductor may overheat and
cause burns.
5. Charge the battery pack provided with or
identified for use with this product only in
accordance with the instructions and
limitations specified in the instruction manudi
provided lor this pixxluct.
6. Observe proprer polarity orientation between
the battery pack and battery charger.
INFORMATION FOR
GENERAL TELEPHONES
Î. This equipment complies with Part 6b of the
FCC rules. On the bottom of this L'quipment
is a label that contains, amor\g other
information, the FCC registration number and
ringer equivalence numl^r fREN) for this
equipment. If requested, this information
must be provided to the telephone company.
2. Tire applicable registration jack (connector;
USOC-RJllC is used for this equipment.
3. This equipment is designed to be connected to
the telephone network or premises wiring
using a compatible modular jack which is Part
68 compliant.
The FCC compliant telephone cord and
modular plug is provided with this
equipment.
4. The REN is used to determine the quantity of
devices which may be connected to the
telephone line. Excessive RENs on the
telephone line may result in the devices not
ringing in response to an incoming call. In
most, but not all areas, the sum of the RENs
should not exceed five fS.Oj.To be certain of
the number of devices that may be connected
to a line, as determined by the total RENs,
contact the local telephone company.
5. If your equipment (SPP-A973) causes harm to
the telephone network, the telephone
company will notify you in advance that
temporary discontinuance of service may be
required. But if advance notice isn't priK li< al,
the telephone company will notify the
customer as soon as possible. Also, ytiu will
be advised of your right to file a complaint
with the FCC if you believe it is necessary.