Cisco 3030 - Manual (Page 37)

2-9
Cisco Catalyst Blade Switch 3030 Hardware Installation Guide
OL-8389-01
Chapter 2 Switch Installation
Installing the Switch Module into the Server Chassis
Step 3 Configure the baud rate and character format of the PC or terminal to match these console port default
characteristics:
• 9600 baud
• 8 data bits
• 1 stop bit
• No parity
• None (flow control)
Step 4 Go to the “Waiting for POST to Complete” section on page 2-11 to finish configuring the switch module.
Connecting through the DRAC/MC
Follow these steps when connecting through the DRAC/MC:
Step 1 Connect one end of a DB9 null-modem or crossover cable to the RS-232 console serial port of the
DRAC/MC. Connect the other end of the cable to the RS-232 console serial port of the computer. (See
Figure 2-5 .)
Note The default data rate of the DRAC/MC console serial port is 115200 baud.
Figure 2-5 Connecting through the DRAC/MC Serial Port
148377
11x 12x
13x
14x 15x 16x
Console
11x
12x
13x
14x 15x 16x
CON