Sony LBT-LX50 - Manual (Page 9)

2
Press TUNING MODE repeatedly
until "AUTO" appears in the
display.
3
Press TUNING+/-.
The frequency indication changes and
scanning stops when the system tunes in
a station. "TUNED" and "STEREO" (for
a stereo program) appear.
Wide display
r.
f I \ I Ij U- El “
mm mm am
Ar/MUU.
■« m%
Normal display
\ i
I n n o
I U LI- J
OOLSYMR
VOLUHE
ALL 06CS ssSSSSSS SS SSS SS SX S
*
MW
'
4
Press TUNER MEMORY.
The next available preset number flashes
in the display. The stations are stored
from preset number 1.
Wide display
M r Ml n n (.1 r K l (V
L ' ' U h J I II \l
\ 1
IE ii Si
mm am am ■■ ■■ am am am m\ u
Mm mm mm mm mm mm mm mm mm mx mm
tm mm am am aa aa am am^ am m\ $ te rm mm am am mm aa am am am mv
----------- 1IIII1%
Normal display
\ C M n Q U C ^ ^ ■</►
\ r_ n u M J r 1 1
► m
«SsssssssSs BS Uss
' SS SS SS SS £= =: rs k k
|i §1 il 1=
£Sr BS SS BS SS BS BS BS BS BB SB T
~
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until
"MANUAL" appears in step 2, then press
TUNING +/- to tune in a station.
To store another station on an
existing preset number
Start over from step 1. After step 4, press
TUNING +/- to select the preset number on
which you want to store the station.
You can add a new preset number after the
last preset number.
To erase a preset number
1 Press and hold TUNER MEMORY until a
preset number flashes in the display.
2 Press TUNING +/- to select the preset
number you want to erase. Select "ALL
ERASE" to erase all preset numbers.
3 Press ENTER/NEXT.
When you erase a preset number, all the
following preset numbers shift up and reduce
by one.
To change the AM tuning interval
(Except for European and Middle
Eastern models)
The AM tuning interval is factory-preset to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval to 10 kHz (or 9 kHz), press TUNER/BAND
repeatedly until "AM" appears, then turn off the
system. While holding down ENTER, turn the
system back on. When you change the interval, the
AM preset stations will be erased. To reset the
interval, repeat the same procedure.
Note
The preset stations are canceled when you
disconnect the power cord or if a power failure
occurs for more than half a day.
5
Press ENTER/NEXT.
The station is stored.
6
Repeat steps 1 through 5 to store
other stations.