Recording on a video tape, 1 select the program source to be recorded, 2 prepare the component for playing – Sony STR-DA333ES User Manual

Page 43: Press sleep on the remote while the power is on, Using the sleep timer

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Using the Sleep Timer

Recording on a video tape

You can record from a VCR, a TV, or an LD player using
the receiver. You can also add audio from a variety of
audio sources when editing a video tape. Refer to the
instruction manual supplied with your VCR or LD player

if you need help.

1

Select the program source to be recorded.

2

Prepare the component for playing.

For example, insert the laser disc you want to record
into the LD player.

3

Insert a blank video tape into the VCR (VIDEO 1 or

VIDEO 2) for recording.

4

Start recording on the recording VCR, then start

playing the video tape or laser disc you want to

record.

You can set the receiver to turn off automatically at a
specified time.

Press SLEEP on the remote while the power is on.

Each time you press SLEEP, the time changes as shown
below.

> 2:00:00 — 1:30:00-» 1:00:00 -• 0:30:00 -• OFF ■

j—» 2:00:0

The display dims after you have specified the time.

? You can freely specify the time

First, press SLEEP on the remote, then specify the time you want

using the jog dial on the receiver. The sleep time changes in 1
minute intervals. You can specify up to 5 hours.

9 You can check the time remaining before the receiver turns

off

Press SLEEP on the remote. The remaining time appears in the

display.

9 You can record the sound from any audio source onto a

video tape while copying from a video tape or laser disc

Locate the point where you want to start recording from another

audio source, select the program source, then start playback. The
audio from that source will be recorded onto the audio track of

the video tape instead of the audio from the original medium.

To resume audio recording from the original medium, select the

video source again.

Notes

• You carmot record a digital audio signal using a component

connected to the analog TAPE REC OUT or MD / DAT REC

OUT jacks. To record a digital audio signal, connect a digital
component to the DIGITAL MD/DAT OUT jacks.

• Please note that you cannot record multi chaimel surround

digital signals from a DVD, etc.

3-

(D

o

■ o

(D

43

Advertising
This manual is related to the following products: