Sony STR-AV910 - Manual (Page 17)

After programming
Be sure to test if the equipment really works with the programmed
signals.
If the LEARN indicator flashes or does not go out In step 2> r, i
The memory capacity has become fuii. This occurs when other
signals stronger than the remote-control signals have been stored
because the signals were programmed in a noisy environment or
the remote commanders were placed too for apart from each
other.
Clear all the signals following the procedure on the right and
program again from the begining under the proper conditions.
Notes on programming
• Remote-control signals of equipment of manufactures other
than Sony can be programmed only when they are compatible
with the infrated wireless remote control system. Since the
programmable commander can “learn" only the signals output
from another remote commander, it cannot control equipment
that do not use a remote commander. Also, note that there are
some special remote-control signals that cannot be
programmed.
• Do not attempt to use the programmable commander with an air
conditioner or other household appliances.
To program a new signal onto a previously programmed
button
Follow the programming procedure.
The previously programmed signal is cleared and replaced by
the new signal.
To clear all programmed signals
1 Set the mode selector to LEARN.
2 Press and hold any button of the programmable area until
the LEARN indicator lights up.
3 Press PROGRAM CLEAR until the LEARN indicator flashes
and goes off.
It is not possible to clear the programmed content of just one
button.
To program a signal onto the • REC button in the TAPE or
VTR section
It is not possible to operate any equipment with only the •
REC button. To program a signal under the • REC button,
press and hold the following buttons at the same time in step
2-1.
TAPE
VTR
Controlling Equipment
By switching the mode seiector as shown below, a single button alternately controls Sony equipment and another
manufacturer equipment.
To control Sony equipment.
SONY
STD
□ □ o o 1=1
tn—i ID nn
____________ I__ I__
To control equipment with
programmed signals
USER STD
When Sony equipment cannot be remote-controlled
Program the signal in the same way as for equipment from other
manufacturers. In this case, even with Sony equipment, set the
mode selector to USER STD.
Battery life
Normal operation can be expected about a half year using Sony
SUM-3 (NS), and a year using Sony AM-3 (NW) alkaline batteries.
If the LEARN indicator does not light when a button is pressed,
the batteries are almost exhausted.
When the batteries are exhausted, the remote commander can no
longer operate the unit or programming becomes impossible.
W this happens, replace both batteries with new ones. We strongly
recommend the use of alkaline batteries.
If no signal has been programmed
The programmable commander can control Sony equipment even
when the mode selector is set to USER STD.
If the equipment works incorrectly
Press RESET and start again. The programmed contents of the
buttons are not cleared by pressing RESET.
17