0 connecting the am antenna, Connecting the fm antenna – Sony STR-AV910 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connecting the FM Antenna
STR-AV910/710
For normal use
For higher quality sound
STRAV1010
75<ohm coaxial cable connection
A 7S^hm coaxial cable is free from external Interference,
reduces noise pickup, and is the ideal transmission line for
most FM installations. 3C-2V cable is recommended.
Connect the 75^hm coaxial cable to the supplied antenna
connector and connect it to the FM antenna connector.
O Open the lid. 9 Strip the cable.
8
{“/n)
10
(“/j
2
)mm(in.)
O Bemove the ring.
(Keep it in the projection on the lid.)
o
Loosen the screws
and insert the cable
0
Coil the center conductor
O Snap the cover into place.
0 Connecting the AM Antenna
Supplied AM antenna
For areas «with difficult AM reception
In areas with troubled reception, connect a
6
- to 15-meter
(20- to SO-foot) insulated wire to the AM antenna terminal.
Extend this out of doors if possible, keeping the geater
portion horizontal.
(There Is no need to disconnect the supplied antenna)
STR-AV910f710
To prevent hum, connect the ground wire to ANTENNA ground terminal (j,).
When an outdoor antenna is installed, be sure to connect the ground wire for lightning protection.