Sony PLM-S700 - Manual (Page 2)

WARNING
■
.■ T:y-:^h
To prevent fire or shock hazard,
do not expose the unit to rain or
moisture. ^
CAUTION
t
CAUTW»* TQftEOUCe THE BiSK Of EtECTWC SHOCK.
OO NOT KWlOVE COVEft K3R ftACIO
HQ US8^^nVCEA8LE BAHTS HSJOt
«EfER SERVK^ TO OUAUREO SERVICE BERSO»MEL
This symbol is intended to
alert the user to the presence
of uninsulated "dangerous
voltage" within the
product's enclosure that may
be of sufficient magrutude to
constitute a risk of electric
shock to persons.
This symbol is intended to
alert the user to the presence
of important operating and
maintenance (servicing)
instructions in the literature
accompanying the appliance.
WARNING
The AC power cord must be changed only
at qualified service shop.
The nameplate is located on the bottom of
the power supply box.
Use a commercially available AC plug
adapter, if necessary, depending on the
design of the wall outlet.
CAUTION
To prevent electric shock, match wide blade
of plug to wide slot, fully insert.
The shielded interface cable recommended
in this manual must be used with this
equipment in order to comply with the
limits for a digital device pursuant to
Subpart B of Part 15 of FCC Rules.
CAUTION
You are cautioned that;
modifications not expr;
this manual could voia
operate this equipmerv
changes or
■ approved in
ur authority to
I-US
INFORMATION
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates, uses,
and can radiate radio frequency energy and,
if not installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the
interference by one or more of the following
mccisures;
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Declaration of Conformity
Trade Name: SONY
Model No.: PLM-S700
Responsible Party: Sony Electronics Inc.
Address:
1 Sony Drive, Park Ridge,
N107656 USA
Telephone No.: 201-930-6970
This device complies with part 15 of the
FCC Rules.
Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any interference
received,
including interference that may cause
undesired operation.