Sony PLM-S700 - Manual (Page 41)

Using the optional battery pack
If you use a battery pack such as the NP-F550/F750/F950, you can use the Glasstron without
connecting to a wail outlet.
Note
You cannot use the Glasstron with the alkaline batteries. Use the AC power adapter (supplied) or the
battery pack (not supplied)
Charging the battery pack
Charge the battery pack before use. You can charge the battery pack using the power supply
box. If you attach the battery pack as described below, the battery pack charges while you are
not using the Glasstron.
Attach the battery pack to the power supply box.
Install the battery pack properly making
sure it is not crooked against the power
supply box. Power supply
To remove the battery pack, while box
sliding ВАТТ RELEASE, puU out the
battery pack. b ATT RELEASE
button
Battery pack
Connect the AC power adapter to the DC IN connector on the
power supply box. Then, connect the AC power cord to the AC
power adapter and to a wall outlet.
Charge the battery pack on a flat place
without vibration.
The CFIARGE lamp lights up. When the
to wall outlet CHARGE lamp
battery pack is fully charged, the
CFIARGE lamp goes out.
Battery life and charging time are shown
in the table on the next page.
AC power
adapter
to DC IN
Notes
' If the POWER/POWER SAVING lamp flashes while using the battery pack, charge the battery pack.
’ If the CHARGE lamp flashes, the power supply box or battery pack is malfunctioning. Contact your
Sony dealer or local authorized Sony service facility.
> Use the supplied AC power adapter only when charging a battery pack.
> Battery life may be shorter in a cold environment. This is a typical battery characteristic.
> You cannot charge the battery pack in power save mode. Turn off the Glasstron, then it starts
charging the battery pack.
continued
41-u