Step 2: hookup, Connecting to an ibm pc/at or compatible computer, Using the front rgb 2 in connector – Sony KL-W7000 User Manual
Page 7: For customers using the supplied hd15-hd15 adaptor, Using the rear rgb 1 in connector
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
step 2: Hookup
Using the rear RGB 1 IN connector
Before making the connection, turn off the power and
disconnect the AC power cords of the monitor and the
equipment to be connected. Refer to the instruction
manual of the equipment you connect.
Connecting to an IBM PC/AT or
compatible computer
Connect the RGB 2 IN connector on the front or the
RGB 1 IN connector at the rear of the monitor to the
video/audio outputs of the computer using the
supplied RGB signal cable (D-sub 15 pin ► D-sub 15
pin).
Using the front RGB 2 IN connector
Front of the monitor
R G B
A U D I O
RGB 2 IN
- f l -
RGB signal cable____
(supplied)
V.
HD15-HD15 adaptor
(supplied)*
Male side
(without the No.9 pin)
to video output
Audio connecting
cord
(stereo minijack »—
stereo minijack)
(not supplied)
to audio output
Rear of the monitor
* The HD15-HD15 adaptor (supplied) may be needed for some
models. The male side (without the No. 9 pin) of the adaptor
should be connected to the computer.
For customers using the supplied HD15-HD15
adaptor
This monitor uses a No. 9 pin in the video signal
connector for,DDCl and DDC2B compatibility.
Some PC systems which are not compatible with either
DDCl or DDC2B may not accept the No. 9 pin. If you
are not sure whether your PC system accepts the No. 9
pin or not, use the HD15 (Female) - HD15 (Male
without the No. 9 pin) adapter (supplied).
IBM PC/AT or compatible
computer
Getting Started
7-EN