Sony KL-W7000 - Manual (Page 9)

Preset and user modes
Preset modes
The monitor has nine factory preset modes for the most
popular industry standards as shown below.
No. Resolution
(dots X
lines)
Horizontal
frequency
(kHz) Vertical
frequency
(Hz) Graphics
mode
1 640 x 400 31.468 70.086 VGA mode
(Text)
2 640 X 480 31.468 59.94 VGA mode
(Graphics)
3 800 X 600 37.879 60.317 SVGA VESA
4 800 X 600 46.875 75.000 SVGA VESA
5 1024 X 768 48.363 60.004 VESA
6 864 X 480 31.469 59.94 Sony
Wide Resolution*
7 1072 X 600 37.879 60.317 Sony
Wide Resolution*
8 1376 X 768 48.363 60.004 Sony
Wide Resolution*
9 832 X 624 49.727 74.553 Macintosh 16" color
* For the timirtg chart of the signals, see page 29.
User modes
when using a video mode that is not one of the preset
modes, some fine tuning may be required to optimize
the display to your preference. Simply adjust the
monitor according to the adjustments instructions on
pages 16 and 17. The adjustments will be stored
automatically and recalled whenever that mode is
used.
A total of 15 user-defined modes can be stored in
memory. If a 16th mode is entered,'it will replace the
first.
Plug & Play
This monitor complies with the DDC tn 'I and DDC2B
which are the Display Data Channel (DDC) standards
of VESA.
When a DDCl host system is connected, the monitor
synchronizes with the V. CLK in accordance with the
VESA standards and outputs the EDID (Extended
Display Identification Data) to the data line.
When a DDC2B host system is connected, the monitor
automatically switches to each communication.
For customers using Windows 95
Install the new model informahon from the "Windows
95 Monitor Information Disk" into your PC. (To install
the file, refer to the supplied "About the Windows 95
Monitor Information Disk/File.")
This monitor complies with the "VESA DDC"
Plug&Play standard. If your PC/video card complies
with DDC, select "Plug and Play Monitor (VESA
DDC)" as "Monitor type" from "Control Panel" in
Windows 95. Some PC/video cards do not comply
with DDC. Even if your computer complies with DDC,
it may have some problems connecting with this
monitor. In this case, select this monitor's model name
(KL-W7000 or KL-W9000) as "Monitor type" in
Windows 95.
Recommended horizontal timing
conditions
Horizontal sync width should be more than 1.0 fisec.
Horizontal blanking width should be more than 3.6
}isec.
When "OUT OF SCAN RANGE" appears on the screen
The monitor receives a signal whose frequency range is not
within that specified for the monitor.
Notes
• When projecting any of the three Wide Resolution signals (864
X 480, 1072 X 600, 1376 x 768), set the picture mode to FULL. In
NORMAL mode, the picture with aspect ratio 16:9 will be
compressed to aspect ratio 4:3 and appear lengthened
vertically. For details, see page 15.
• The monitor does not accept an interlace mode signal.
Getting Started g-EN