Connecting to a tv without a/v jacks caution – Sony INT-W100 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connecting to a TV without
A/V jacks
Caution
If you connect your Internet Terminal to
a projection TV, prolonged use of your
Internet Terminal may degrade your
projection TV's picture tube, by causing
an imprinted image to remain on the
screen.
If your TV does not have A/V jacks, you must use an RFU adaptor (optional
accessory) to connect the Internet Terminal to your TV.
Internet Terminal
Audio is monaural with this adaptor.
Refer to your RFU adaptor manual for
more information.
Set the channel switch on the RFU adaptor to VHF channel 3 or 4, whichever
does not receive a broadcast station in your area.
1
Connect the RFU adaptor to the VIDEO and AUDIO jacks on the Internet
Terminal.
2
Connect the OUT plug on the adaptor to the ANTENNA jack on the back
of your TV. You may need to disconnect the antenna cable from your TV
to make this connection. Connect the antenna cable or cable line to the
ANT jack on the RFU adaptor.
3
Connect one end of the telephone line cable to the Internet Terminal's
TEL LINE jack. Connect the other end to your home's telephone outlet.
4
Connect one end of the AC power cord to the Internet Terminal's AC IN
jack. Connect the plug end to an AC outlet.
Only use the supplied AC power cord.
5
Set your TV Channel to 3 or 4 , depending on which channel the RFU
adaptor is set to, when using the Internet Terminal. When you are
watching TV, make sure your Internet Terminal is turned off.
Chapter 2: Connecting Your System
9