Sony CDP-C225 - Manual (Page 18)

When playback of a disc ended before the designated
playing time
The time fade function wili remain effective even for a new
disc(s) added for the remaining piaying time originaiiy
designated, and the fade out starts in accordance with the
initiaiiy set fade time.
To cancel time fade
Time fade wiii be canceied when
-EDIT/TiME FADE is pressed once again.
(manual search) is pressed during play.
To illsplay the tíme remaining until the time set
Press TIME twice.
If the PEAK SEARCH is pressed after setting time
fade,
time fade is reieased but peak search is kept active.
Locating the Loudest Portion of
the Disc - Peak Search
ri
The unit wili scan a disc from beginning to end and
determine the ioudest portion (peak ievei) of the disc, and
then play that portion repeatedly. This function wiil make it
easier for you to adjust to the optimum ievei when
recording on tape. You can use this function in the
continuous or shuffie play mode only for a disc which is in
play position currentiy, and in the program play mode for
the selections of the entire program.
To set peak search
Press PEAK SEARCH in the stop mode. "PEAK” flashes
in the window. The entire tracks in a disc or program wili
be searched automaticaliy. "PEAK" iights up and the
loudest portion will be played repeatedly for 4 seconds.
Adjust the recording level on your tape deck according to
the peak level.
Note
To go to another disc press DISC SKIP button dunng stop.
To stop peak search
Press ■.
Press
II
to pause at the first selection.
To start play immediately
Press ►.
Note on peak search function
The unit determines the loudest portion (peak level) of a disc
by searching it at fixed intervals. As a result, the portion
searched may differ from the actual peak level. In addition, this
function may determine different portions as the peak level for
the same disc. However, the difference between the portion
searched and the actual peak level is insignificant aixf will not
present any problem in adjusting the recording level.
18