Sony CDP-C225 - Manual (Page 19)

Maintenance Specifications
Cleaning the CABINET
Clean the cabinet, panel and controls with a soft cloth
lightly moistened with mild detergent solution. Do not use
any type of abrasive pad scouring powder or solvent such
as alcohol or benzine.
Cleaning DISCS
Before playing, clean the disc with the cleaning cloth.
Wipe the disc from the center out.
Do not use solvents such as benzine, thinner,
commercially available cleaners or einti-static spray
intended for analog discs.
After playing, store the disc in its case.
System
Laser
Laser output
Frequency response
Signal to noise ratio
Dynamic range
Harmonic distortion
Channel separation
Wow and flutter
Outputs
General
Power requirements
Power consumption
Dimensions
Weight
Compact disc digital audio system
Semiconductor laser (\=780 nm)
Emission duration: continuous
Max. 44.6 jLiW*
* This output is the value
measured at a distance of
about 200 mm from the
objective lens surface on the
Optical Pick-up Block.
2 Hz - 20 kHz (±0.5 dB)
More than 100 dB
More than 98 dB
Less than 0.005%
(1 kHz)
More than 100 dB (1 kHz)
Below measurable limit
LINE OUT (phono jacks)
Output level 2 V (at 50 kilohms)
Load impedance over 10
kilohms
PHONES (stereo phone jack)
Output level 0 - 1 0 mW
(variable) (at 32 ohms)
Model for USA and Canada
120 V AC, 60Hz
Model for Australia
240 V AC, 50/60 Hz
12 W
Approx. 430 X 125 X 385 mm
(w/h/d) (17 X 5 X 15% inches)
including projecting parts and
controls
Approx. 5.6 kg (12 lbs
6 oz), net
Remote commander RM-D325 (CDP-C425/C325 only)
Remote control system Infrared control
Power requirements 3 V DC with two batteries size AA
(lEC designation R 6 )
Supplied accessories
Audio signal connecting cord
(phono plug X 2*-* phono plug x 2) (1)
Remote commander (1) (CDP-C425/C325 only)
Sony SUM-3 (NS) batteries (2) (CDP-C425/C325 only)
Operating Manual (1)
Design and specifications subject to change without
notice.
19