Troubleshooting guide – Sony CDP-C225 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Troubleshooting Guide
The following checks will assist in the correction of most problems which you may encounter with your unit.
Shouid any problem persist after you have made these checks, consult your nearest Sony service facility.
Before going through the check list below, first refer back to the connection an operating procedures.
Trouble
Causes
Remedy
No audio from one or both channels
Incorrect operation of the amplifier
Operate correctly.
Loose connection
Connect the cords firmly.
Play does not begin.
No disc in the disc compartment
Put disc(s) in the compartment
The player is in the pause mode.
Press ^ or
II
to release pause.
Moisture condensation
Leave the player turned on for about an
hour.
The disc is set upside down.
Set the disc with the label side up.
The disc is tilted.
Set the disc correctly.
The disc is extremely dirty.
Clean the disc.
Remote commander does not operate the
unit (For CDP-C425/C325 only)
The batteries are exhausted.
Replace both batteries.
The remote commander is not pointed at
the remote control sensor.
Point the remote commander to the sensor.
There is an obstacle between №e remote
commander and the unit
Remove the obstacle.
The remote commander is too far from the
unit
Move closer.
Any operation is not possible.
The internal control program may not run.
Turn off the power and turn it on again.