Sony KV-32XBR45 - Manual (Page 38)

Operating a cable
box
Use POWER(CABLE) and the TV control
buttons (0 - 9, ENTER, JUMP and CH +/-) to
operate the cable converter box.
® (D @
® ® ®
® (D (9)^
ENTER ® o
Setting the manufacturer's code
Follow these instructions to set the manufacturer's
code which will enable you to operate a connected
cable box with the pre-programmed remote control.
For example, you can set the remote control to operate
a cormected Zenith cable box as follows:
MODE
Low position
POWER (CABLE)
10 O 01
o o o
o o o
i O l 3 ^
l\l©
e CH +/-
CABLE BOX/TV
selector \~ ~ /
1
Set the CABLE BOX/TV selector to CABLE
BOX.
CABLE BOX. .TV
2
While pressing CODE SET, press 6 and 8
(Zenith's code number —see chart on right)
and ENTER.
^ odeset |(0 ) +
JUMP
To operate the TV
Set the CABLE BOX/TV selector to TV. Then use the
TV control buttons to control the TV.
For more details on operating the cable box
Refer to the operating instructions that come with the
cable box.
Manufactures and code numbers (cable box)
Manufacturer Code number
JERROLD 60, 61, 62, 63, 64, 65, 73
JUMP PIONEER 69, 70
0-9 buttons
SCIENTIEIC ATLANTA 66, 67
TOCOM 71, 72
ENTER ZENITH 68
Notes
• If more than one code number is listed, try entering them one by one
until you come up with the correct code for your equipment.
• If you enter a new code number, the code number you
previously entered at that setting is erased.
• In some cases, your equipment may use a code that is not
provided with this remote control and you may not be able to
operate your cable box with the supplied remote control. In
this case, use the equipment's own remote control unit.
• When you remove a battery from the remote control, the code may
be erased. Reset the code each time you replace the battery, if
necessary.
• The JUMP button may not work or cause another function in
some cable boxes.
33 Operations