Setting the manufacturer's code, Manufacturer code numbers (cable box), Manufacturer code numbers (satellite receiver) – Sony KP-48V80 User Manual

Page 57: If the remote control doesn't work, To operate the projection tv, Operating a cable box or satellite, Receiver (sat)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Operating a Cable Box or Satellite Receiver (SAT)

Setting the Manufacturer's
Code

You can program the supplied remote control
to operate a cable box or satellite receiver.

Press CODE SET, SAT/CABLE
(FUNCTION), and the 0-9 buttons to enter
the manufacturer's code number (see the
following chart), then press ENTER.

For example, to operate a Sony satellite
receiver:

FUHCTWM

COOESET SAT/CABLE .

.

gp+c;i + (8j + coj-f

Manufacturer

code numbers

(cable

box)

Manufacturer

Code

Hamlin/Regal

222, 223, 224, 225, 226

Jerrold/G. 1.

201,202, 203, 204, 205,

222, 206, 207, 208, 218

Oak

227, 228, 229

Panasonic

219, 220, 221

Pioneer

214, 215

Scientific Atianta

209, 210, 211

Tocom

216, 217

Zenith

212, 213

Manufacturer code numbers
(satellite receiver)

Manufacturer

Code number

Sony

801 (preset code for

remote control)

Geneai Eiectric

802, 808

Hitachi

805

Hughes

804

Panasonic

803

RCA/PROSCAN

802

Toshiba

806, 807

To operate the cable box or
satellite receiver (SAT)

1

Press SAT/CABLE (POWER) [Green

Button] to turn on/off the cable box or
satellite receiver.

Press SAT/CABLE (FUNCTION).

For other operations, refer to the
operating instructions that come with the
equipment.
The GUIDE and INDEX (blue-labeled)

buttons can be used only with a satellite
receiver.

2

3

If the remote control doesn't work

• Try repeating the set up procedures using

the other codes listed for your equipment.

To operate the projection TV

Press TV (FUNCTION). Then use the

projection TV control buttons to control the
projection TV.

Tips V

If more than one code number

is

listed, try entering

Iheiii one by one until you come to the correct code for
your equipment.

If you enter a new code number, the code number you

preihously entered at that setting is erased.

• In some rare cases, you may not be able to operate

your equipment with the supplied remote control. In

this case, use the equipment's own remote control
unit.

Whenever you remove the batteries

to replace

them, for example

if too much time is taken, the

code numbers may revert to the factory setting and
must be reset.

53

Advertising
This manual is related to the following products: