Sony CDP-C910 - Manual (Page 9)

Playing a Disc - Continuous Play
Before playing a disc, turn on the amplifier and set the
input selector to the CD player position.
To stop play
To stop for a moment during play, press II.
Press ► or II to resume play.
To stop play, press ■.
To stop play and remove the disc magazine, press
A
EJECT.
Caution on adjusting voiume
Do not turn up the volume while listening to a portion
with very low level inputs or no audio signals. If you do,
the speakers may be damaged when a peak level
portion is played.
To listen with the headphones
Connect the headphones and control the volume with
PHONE LEVEL/LINE OUT LEVEL control or LINE OUT
LEVEL buttons on the remote commander.
Notes
• Disc memo (see page 22) appears in the display window during
the stop mode. If the disc memo is not stored, the disc
number-such as "-X-DISC-1-X-", is displayed.
■ When a magazine is loaded, all slot numbers will be displayed
until that slot is recognized as empty. Empty slots are
recognized when ► is pressed. The corresponding numbers will
disappear.
• NO DISC is displayed when the magazine is not loaded in
the unit, or when the magazine is empty.
You can change the NO DISC display. See page 22 for
procedure.
• The play mode in use before turning the power off is retained in
memory.
About the SEE YOU 1- ” display
The SEE YOU ! display only appears after ejecting the
magazine. A few seconds later, the display will change to NO
DISC