Nikon AC-2WE - Manual (Page 24)

Connecting the Camera to a Personal Computer with the FI 00
To connect the Nikon FI 00 camera to your personal computer, use only Nikon
Personal Computer Connecting Cord MC-33 or MC-31. A data link cannot be estab­
lished with any other connecting cord.
Connecting
3.
4.
Turn off both the camera and personal computer.
Connect the MC-33 or MC-31 to the camera’s
10-pin remote terminal.
Insert the cord's plug into the terminal with the
“A” symbol pointing to the dot at the upper left
of the terminal, then turn the lock screw as far as
it will go. (Fig. 9)
Connect the MC-33 or MC-31 to the personal
computer’s RS-232C serial port.
Match the shape of the cord’s connector with
the personal computer’s terminal, then push it in
and tighten the two screws on the plug.
Turn the computer on, start Windows®, then
turn the camera on.
Disconnecting
1. Quit Windows®, then turn off both the camera
and personal computer.
2. Remove the cord's connector from the personal
computer.
Loosen the two screws on the connector, then
pull it out.
3. Remove the cord’s plug from the camera body.
Unscrew the lock ring, then unplug the cord.
(Fig. 10)
(Fig. 10)
11