Multiple exposure lever – Nikon FM2 User Manual
Page 41
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Multiple exposure lever @
Taking a picture of different subjects or two or more of the same
subject on the same frame means multipie exposure. To make a
multiple exposure, observe the following:
1) Take the first shot. (Press the shutter release button.)
2) Pull the multiple exposure lever in the direction of the arrow
shown in the photo, as you wind the film advance lever fully.
The frame counter will not advance; only the shutter is ready
to be released again. Although the finger pulling the multiple
exposure lever will automatically slip off the lever as the film
advance lever is wound, multiple exposure operation will
have been performed correctly,
3) After winding the film advance lever fully, take the second
shot.
To take three exposures or more on the same frame, repeat the
procedures described in 2) and 3).
Note: In multiple exposure photography, the FM2 is designed to reduce
film dislocation to the minimum. But It may occur due to film curling, film
slack or inappropriate film winding.