Canon EOS 50E - Manual (Page 86)

Troubleshooting Guide
■ ............. ■ ■ “Tiiltzr." ...........
If there is a problem, follow the solutions in this Troubleshooting Guide. If
the problem still persists, take your camera to your nearest Canon
Service Center. Canon Service Centers are listed on the back of this
Instructions booklet.
Problem Probable Cause Solution Page No
1 Nothing is displayed on the
LCD panel
The battefy is exhausted Replace the battery with a new
one.
17
The battery has been installed
incorrectly
Install the battery correctly
17
2 The shutter does not
release.
The film has not been loaded
correctly (The frame No is not
displayed on the LCD panel)
Load the film correctly
21
Rewound film is still In the
camera. (The frame counter on
the LCD panel displays ^ .)
Take out the film cartridge and
load a new roll of film 23
Focus has not been achieved.
(The in-focus indicator in the
viewfinder is blinking )
Press the shutter button
halfway until focus is achieved.
If focus still cannot be
achieved, set the focus mode
switch on the lens to M and
focus manually.
39
3 The photograph is out of
focus
The focus mode switch on the
lens has been set to M
(Manual)
Set the focus mode switch on
the lens to AF (Autofocus) 19
The shutter speed is too slow
to prevent blur caused by
camera shake
Press the shutter button
without shaking the camera or
use a faster shutter speed
20
4 Only blinks on the
LCD panel.
The battery level is very low. Replace the battery with a new
one and check that the battery
level is displayed on the LCD
panel.
18
The camera is not operating
properly
Press the shutter button
halfway and check that the
battery level is displayed on the
LCD panel
18
Back
cover
86