Setting up the dvr unit, Installing the hard disk, 4 setting up the dvr unit – AVer EB3004 NET & NET+ User Manual
Page 10: 1 installing the hard disk
4
1.4
Setting Up the DVR Unit
1.4.1 Installing the Hard Disk
i
For hard disk spec, please referring
→ Embedded Analog
DVR → AVerDiGi EB3004 NET or AVerDiGi EB3004 NET
+
→ Hardware Recommendations
The “compatible hard disks” indicated in the above recommendation list only means that these commercially
available hard disks were tested with AVerMedia products and functioned well under normal operation
conditions. AVerMedia does not guarantee or provide warranties, explicitly, implied or statutory with respect to
the reliability of the hard disk function or its compatibility. In no event AVerMedia shall be liable for damages,
with respect to any business interruption of clients, lost profits, loss of programs or other data on your
information handling system or otherwise. This includes direct, indirect, incidental, special, or consequential
damages, resulting from the incompatibility caused by the usage of these hard disks, even if AVerMedia has
expressly advised about the risk of such damages. The entire risk arising out of the use of any information
attached here with is borne by the recipient.
The DVR unit allows user to install one hard disk. Follow the illustrated instructions below to install the
hard disk:
1.
Loosen all screws
2.
Push the cover backward and lift
3.
Secure the brackets on the hard disk
4.
Connect the the SATA cable and the power connector
to the hard disk