AVer EB3004 NET & NET+ - Manual (Page 38)

32
OSD MENU Description
SENSOR SETUP
TYPE
ENABLE
SENSOR1 SENSOR2 SENSOR3 SENSOR4
NO NO NO NO
SENSOR
Customize the initial state of the attached sensor.
ENABLE
Active/deactivate the sensor.
TYPE
Select the state of the sensor.
- NO: Indicates that the initial state of the sensor is normal open. Video
recording initiates when there is a changes in the sensor state
- NC: Indicates that the initial state of the sensor is normal close. Video
recording initiates when there is a changes in the sensor state
MOTION DETECTION SETUP
SENSTIVITY
ENABLE
CH1 CH2 CH3 CH4
5 5 5 5
MASK SETUP
MOTION DETECTION
Setup motion detection. The motion detection setup will relate to the
MOTION DETECTION in ALARM SETTING.
ENABLE
Enable/disable the channel to detect motion.
SENSITIVITY
Set the sensitivity level. The sensitivity is from H (High), 9~ 2 and L (Low).
MASK SETUP
Select a specific area for motion recording. The DVR system will start
recording when the selected area has been detected motion.
MAIN MENU
CAMERA/RECORD
SCHEDULE
EVENT SETUP
DISPLAY
STORAGE
NETWORK
SYSTEM
STORAGE SETUP
To format hard disk and enable/disable hard disk spaces recycle.
STORAGE SETUP
HDD SIZE
HDD OVERWRITE
HDD USED
HDD FORMAT
VIDEO BACKUP
953 , 849MB
279MB 0%