AVer EB3004 NET & NET+ - Manual (Page 64)

58
8.1.1.3 Record Setup
(1)
(2)
(3)
(1) Record Mode
Select D1/CIF/D1 Enhance recording mode.
Under D1 mode, the total recording frame rate is 60/50fps (NTSC/PAL). The video recording is in full
screen resolution and takes turns from one channel to the next one when Auto Scan enables. Each
channel is recorded only at a maximum frame rate of 30/25 fps (NTSC/PAL). User can switch to view
the video in single full screen or QUAD screen.
In D1 ENHANCE mode, the total recording frame rate is 30/25fps (NTSC/PAL). Each channel can be
recorded at a maximum frame rate of 30/25 fps (NTSC/PAL).
Whereas in CIF mode, the total recording frame rate is 120/100fps (NTSC/PAL). The video recording
is at a lower resolution, but all channels can be recorded at a maximum frame rate of 30/25 fps
(NTSC/PAL). User can switch to view the video in single full screen or QUAD screen.
(2) Channel Setting
Setup parameters of each channel.
- Enable
Enable/disable the channel to display the video on the surveillance screen. If the channel is
disabling, there won
‟t be any video display and recording.
- Record
Enable/disable the channel number to record video.
i
The channels are enabled can be set for video recording.
- Audio Record
Enable/disable audio recording. To record sound, make sure the audio input device (ex:
microphone) is connected to the DVR unit.
- Preview
Enable/disable the video preview on the surveillance screen.