AVer EB3004 NET & NET+ - Manual (Page 31)

25
3.1 Menu Function
Use remote control to navigate in the OSD menu. The red frame turns yellow when you are making a
selection.
Each time you change the video display output or video system (NTSC/PAL), the power must be
turned off and on to reset the DVR unit.
OSD MENU Description
MAIN MENU
CAMERA/RECORD
SCHEDULE
EVENT SETUP
DISPLAY
STORAGE
NETWORK
SYSTEM
CAMERA/RECORD SETUP
Configure camera parameters, name and PTZ camera.
CAMERA / RECORD SETUP
GENERAL
CHANNEL SETTING
PTZ
CHANNEL NAME
GENERAL SETUP
GENERAL SETUP
RECORD MODE
TIME STAMP
DVR NAME
WATERMARK
AUTO RECORD
CIF
COMPANY
RECORD MODE
Three type of recording mode -- D1/CIF/D1 Enhance.
Under D1 mode, the total recording frame rate is 60/50fps (NTSC/PAL).
Each channel is recorded only at a maximum frame rate of 30/25 fps
(NTSC/PAL).
In D1 ENHANCE mode, the total recording frame rate is 30/25fps
(NTSC/PAL). Each channel can be recorded at a maximum frame rate of
30/25 fps (NTSC/PAL).
Whereas in CIF mode, the total recording frame rate is 120/100fps
(NTSC/PAL). The video recording is at a lower resolution, but all channels
can be recorded at a maximum frame rate of 30/25 fps (NTSC/PAL).
DVR NAME
Assign a name for the DVR unit. Maximum is 10 characters that may
contain A~Z, 0~9, !,
“, #, $, %, &, „, (, ), *, +, -, /, :, ;, <. >, ?, @, and space.
TIME STAMP
Enable/disable the time and date display on the each channel.
AUTO RECORD
Enable/disable auto continue recording when interrupted (i.e., power
breakdown, video playback or configuration setup). It starts to record after 5
seconds of idleness. This is applicable in Always Record mode.