AVer SD1306 user manual - Manual (Page 64)

60
Event > Arrangement > Motion
Motion Detection: IP camera only allows whole area motion detection. When motion is triggered, it
can send the video to some specific mail addresses, transmit the video to remote ftp server, trigger the
relay, and save video to local microSD/SDHC card. To start the motion detection, please check
“Enable”.
Interval: It
’s the period between two motion detections. For example, if you select "10 sec" here, once
the motion is detected and action is triggered, it cannot be triggered again within 10 seconds.
Based on the schedule: The motion detection is enabled only during the schedule time the. That is,
for example, 11:00~12:00 of Monday has not been colored in the schedule table, then no action will be
triggered even the camera detects motion during 11:00~12:00 on Monday.