CDI Torque TORQUE WRENCHES Micro-Adjustable Click Type - Manual (Page 22)

Page 18
HANDLE/LOCK RING REPAIR
These instructions are to be used for the repair of the handles or lock rings. Calibration
does not require the handle to be disassembled.
To Disassemble the Handle/Lock Ring
1. Remove the button or rubber plug with a flat blade mini screwdriver.
NOTE
There are two distinct end plugs for the torque wrenches.
They are:
•
Steel button plug with a prongs, which requires 4 drops of adhesive (locktite 495) at
the top, bottom and sides.
⇐
Steel Button
•
Rubber plug that requires a groove inside of the handle end for installation.
A steel button plug may be placed into a handle end with a groove on the inside diameter.
A rubber plug may not be used on a handle without a groove on the inside of the handle.