CDI Torque TORQUE WRENCHES Micro-Adjustable Click Type - Manual (Page 29)

Page 25
4. Place the wrench on a torque tester and turn adjustment screw (4) with a T handled
hex ( 1/8” or 3/32”) until the desired setting is on the torque tester when a load is
applied.
CDI Pre-Set (Click) Torque Wrench Ranges & Adjustment Tool Part Numbers
Torque Ranges Adjustment
Tool
Part #
Hex
Size Part
Number
in./ft. lb. dNM/NM. cmkg/mkg
5T-I 16-60 in. lb. 14-67 dNM 14-69 cmkg 600-45-01 3/32”
10T-I 36-108 in. lb. 40-122 dNM 42-124 cmkg 600-45-02 1/8”
10ST-I 84-300 in. lb. 95-338 dNM 110-385 cmkg 600-45-02 1/8”
10AT-I 84-300 in. lb. 95-338 dNM 110-385 cmkg 600-45-03 1/8”
50ST-I 10-50 ft. lb. 14-67 NM. 1.4-7 mkg. 600-45-03 1/8”
50T-I 10-50 ft. lb. 14-67 NM. 1.4-7 mkg. 600-45-03 1/8”
100ST-I 30-150 ft. lb. 41-200 NM. 4.1-20 mkg. 600-45-04 1/8”
100T-I 30-150 ft. lb. 41-200 NM. 4.1-20 mkg. 600-45-04 1/8”
200T-I 40-200 ft. lb. 55-270 NM. 5.5-27 mkg. 600-45-04 1/8”
300T-I 60-300 ft. lb. 82-400 NM. 8.2-40 mkg. 600-45-05 3/16”
600T-I 200-600 ft. lb. 275-800 NM. 27.5-135 mkg. 600-45-06 3/16”
5. Tighten the locking screw (1). Test wrenches setting three more times. If the readings
are correct, place torque seal into the locking screw (1) hex opening to prevent
tampering.
6. Place button plug (2) back into the handle end by inserting it into one side of the
opening then applying pressure with your finger until it is fully engaged.
TROUBLESHOOTING
The Pre-Set Torque Wrenches generally do not require repair. They are sent in for
calibration to the required use setting with the head or adapter chosen for use. All
adjustments are to be made as shown in the section on Pre-Set Torque Wrench
Calibration.
The Troubleshooting Matrix is for the Micrometer Adjustable Wrench models only.
Refer to the Troubleshooting Matrix for problems that could occur to the Micrometer
Adjustable Torque Wrenches and their remedy.