CDI Torque TORQUE WRENCHES Micro-Adjustable Click Type - Manual (Page 27)

Page 23
5. Next, set the handle on the lowest increment of the tube. Pull the lock ring down to
the unlock position and turn the handle until the top of the handle scale is lined up
with the lowest increment on the tube. Release the lock ring to engage balls into the
splines on the tube.
NOTE
The top of the handle must touch the increment line on the tube scale. When “0” is set,
the top of the handle cannot cover up the increment line on the tube scale or be below it.
6. If the center line of the tube is not lined up with the “0” on the handle, pull down on
the lock ring to unlock it, pull the handle back off of the flange nut on the tube screw
(approx. ¼”). Turn the handle to reset the flange nut into the handle insert so that the
“0” is lined up with the centerline of the tube scale. Release the lock ring and jiggle
the handle lightly left and right until the lock ring is fully engaged.
NOTE
Wrenches with maximum ranges from 50 in. lb. to 250 in. lb. require a lock washer on
the handle (see exploded illustration for lock washer part number). Do not reuse the lock
washer. Use a new lock washer when reassembling the handle to the tube.
7. Tighten the hex flange nut with a 200 in. lb. torque wrench as follows: