Detex 14DV Trim User Manual
Page 2
PREPARING THE TRIM
1. The lever trim is handed. Refer to “CHANGE LEVER HANDING” on pages 4 and 5 if needed.
INSTALLING THE MORTISE CYLINDER -08 and 09 FUNCTIONS ONLY - Instruction 2 and 3:
2. A short cylinder collar is supplied for mortise cylinders 1” to 1-1/8” long. For cylinders greater
than 1-1/8”, order tall cylinder collar part #100752-X.
3. Insert the mortise cylinder (not included). (See Fig. T8). Fasten the cylinder with the large hex
nut. Note: The key should turn the cylinder easily to slide the locking bar in both directions.
Caution: The back of the cylinder should not protrude beyond the depth of the trim escutch-
eon.
Fig. T8
PREPARING THE TRIM - CONTINUED - FOR 08 FUNCTION, 09 FUNCTION AND 14 FUNCTION:
4. Attach the tail piece extension to the top gear with screw provided.
PREPARING THE DOOR:
5. Center punch holes “a” and “d” marked earlier.
6. Drill two (2) pilot holes “a” (holes located diagonal from each other for standard stile). Caution:
Be sure to drill STRAIGHT through the door .
7. Drill pilot holes for remaining holes “a” through inside of door only.
8. Drill pilot hole “d”. Caution: Be sure to drill STRAIGHT through the door .
9. Using Back Plate as template on outside, align the two (2) pilot holes “a”. Mark, center punch
and drill pilot holes for the two (2) remaining holes “a”.
10. At the outside and inside trim cam hole “d”, drill a 3/4” hole.
DETEX INS-101295 Page 2
Not Included
(order part
#102281-X)
100572-X
Short Collar
included