Detex 14DV Trim - Manual (Page 4)

DETEX INS-101295 Page 4
CHANGE LEVER HANDING
(Refer to Fig. T11 on page 5)
A. Remove tailpiece extension assembly screw. (Remove tailpiece extension assembly if neces-
sary).
B. Remove stop plate.
C. Warning: Springs under pressure! Remove spring retaining plate. Carefully remove the
springs.
D. Switch lock spring to opposite side (for 09 Function only).
E. Remove top gear.
F. Loosen the clutch center screw approximately two (2) turns. Bend locking tab back to disengage
with notch.
G. Slide the locking bar away from the rack (not necessary for 14 function). Remove the rack while
rotating the lever.
H. Continue rotating the lever to the opposite side.
I. Rotate the lever to the position shown. Partially engage the rack and the clutch gear on the
opposite side.
J. Rotate the lever until the rack is completely seated.
K. Insert the top gear.
L. Add permanent thread locking adhesive and tighten the clutch center screw. Bend tab over
screw notch so that screw cannot turn.
M. Warning: Springs under pressure! Install the springs. Hold the lever in the open position,
firmly compressing the springs in place.
N. While holding the lever in the open position, replace the spring retaining plate and fasten the two
(2) screws.
O. Reverse the stop plate and fasten the screw.
P. Replace tailpiece extension assembly screw. Handing complete.