Dynojet 250iP: Air Brake and EEC Kit - Manual (Page 10)

Air Brake and EEC Kit Installation Guide for 200i/250i and 200iP/250iP Motorcycle Dynamometers
A I R B R A K E A N D E E C K I T
Air Brake
6
10 Remove the two 5/16-inch bolts and washers securing each of the carriage clamps
and shims and set aside.
11 Remove the three carriage clamps and shims and set aside.
12 Remove the two 5/16-inch bolts and washers securing the nut block and shim and
set aside.
13 Remove the nut block and shim and set aside.
14 Remove the six 1/4-20 x 5/8-inch pan head screws securing the center panel to the
dyno carriage and set aside.
15 Remove the center panel and set aside.
Figure 4: Removing the Center Panel
screw
center panel
carriage
clamp
washer
bolt
shim
nut block