Dynojet 250iP: Air Brake and EEC Kit - Manual (Page 31)

I N S T A L L A T I O N G U I D E
EEC Finger Guards—200iP/250iP
Version 1 Air Brake and EEC Kit Installation Guide for 200i/250i and 200iP/250iP Motorcycle Dynamometers
27
8 Secure the right drum guard to the drum guard mount using the two
1/4-20 x 5/8-inch pan head screws and locknuts removed earlier.
Do not operate the dynamometer without the EEC finger guards properly
installed. The gap between the finger guards and the drum must be less than
0.64 centimeters (0.25 inches). Refer to page 28 for instructions on adjusting
the gap.
Figure 27: Securing the Drum Guard to the Drum Guard Mount
FRONT OF DYNO
PD072
screw
drum guard mount
locknut